Crocodile Clip with Pigtail - male jumper connector (4 Pack)

A 4 pack of wires that are pre-terminated with a crocodile clip on one end and a hookup pigtail (male jumper connector) on the other.

This is a 4 pack of wires that are pre-terminated with an alligator (crocodile) clip on one end and a hookup pigtail (male jumper connector) on the other. crocodile clips are a staple part for any workbench and with these cables you will be able to easily incorporate those clips into a breadboard, development platform, or anything else that you would normally be able to attach a male jumper connector to.

Each Crocodile Clip with Pigtail cable has a wire length of 30cm (thats a little less than 1ft) and a male pin that easily inserts into a standard 0.1" connector. Each pack consists of two red cables and two black cables.

These connector wires can also be used to connect a BBC micro:bit to a prototyping board as an alternative to an edge connector.

Features:

• Wires with a crocodile clip on one end and a male jumper cable connector (pigtail) on the other.
• Enables you to connect a BBC micro:bit to a prototyping board as an alternative to using an edge connector.

Contents:

• 2 x Red crocodile to male jumper connector leads.
• 2 x Black crocodile to male jumper connector leads.